Rokonet ORBiT-14 Uživatelský manuál stáhnout pdf (Strana 32)

Installation and Programming Manual

The LCD Keypad offers you the facility to navigate through the menu structure as you see fit–to reach your desired

destination(s). Before beginning, be sure your ORBIT-Pro is connected to an LCD Keypad which has been given

the physical I.D. of “01”, and to a power source (AC and Standby Battery). After applying power to your system,

locate the display produced by your keypad. Then read and follow the applicable comments in the appropriate

column.

With power applied, this display

represents an ORBIT-Pro which is

unprogrammed (i.e. has stored only

factory defaults) OR one whose LCD

Keypad is not properly identified to the

system.

To enter Installer Programming from

this type of display, press the [QQ] key

and proceed to the steps, directly

below.

This display represents that of a previously-programmed ORBIT-

Pro in which the term “PARTITION 1” is the name designated for

the system or for one of its partitions. To enter Installer

Programming from this type of display, press the [QQ] key and

proceed to the steps, below.

Note: If the time and date have NOT been

previously programmed or if power to the system has been

interrupted, the display will show “blanks” for these fields on the

bottom line.

1- If the panel has never been

programmed, or still uses the default

Installer Code, enter

[ 0 ] [ 2 ] [ 9 ] [ 6 ]

If there is another Installer Code

assigned to this panel, enter it

instead.

2- Once done, press [ENTER].

3- The display will show:

which is the starting point each time

you enter Installer Programming.

1- From the display showing:

press [7] to select:

and press [ENTER].

2- Enter the Installer Code currently in use for this panel, or use the

factory default [ 0 ] [ 2 ] [ 9 ] [ 6 ], if applicable,

and press [ENTER].

3- The display will show:

which is the starting point each time you enter Installer

Programming.

Although these steps may have been performed earlier, it’s always a good idea to check that the LCD

Keypad from which programming is to be performed has been properly identified to the ORBIT-Pro. To do

so, perform the procedure in pages 27 and 28.

To Install

Press SS

PARTITION 1

--:-- ... .. ...

INSTALLER CODE:

USER FUNCTIONS

1)BYPASS ↓↓

INSTALLER PROG:

1)ADVANCED ↓↓

INSTALLER CODE:

INSTALLER PROG:

1)SYSTEM ↓↓

INSTALLER PROG:

1)SYSTEM ↓↓

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 69 70

Komentáře k této Příručce

Žádné komentáře

Rokonet ORBiT-14 Uživatelský manuál Strana 32

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Rokonet ORBiT-14